This easy-to-string pearl bracelet project combines teardrop pearls, flat spacers, seed beads, round beads, and crimp beads on flexible bead wire.
See the project instructions below, or download the free project PDF above.
Supply List
Instructions
1. Determine the finished length of your bracelet, add 5 in. (13cm), and cut a piece of beading wire to that length. String a round spacer, a crimp bead, a round, and half the clasp. Go back through the beads just strung, crimp the crimp bead, and trim the excess wire.
2. String three pearls, a flat spacer, a seed bead, and a spacer. Repeat this pattern until the bracelet is within 1 in. (2.5cm) of the desired length.
3. String the beads and the remaining clasp half as shown in step 1. Check the fit and add or remove beads, if necessary. Crimp the crimp bead and trim the excess wire.
Do you beading?
Then you’ll want to subscribe to Bead&Button magazine! You’ll get exclusive projects, gorgeous design inspirations, helpful advice about new products, and much more!
beading?